Table of Contents
Advertisement
2) Enter the required value of coordinate, using the numeric keypad ([DEL] – Deletes the entered
character; [ESC] – Cancels the option of entering a value).
3) Accept the entered value, by pressing [ENT].
4) Declaration of coordinate for another axis – go back to item 1.
5) Confirm the declared coordinates, by pressing [F1] "Accept".
The following keys are available, when this function is carried out:
"
"
[F2]
Reset
: It enables resetting operator's coordinates.
2.2.2 A list of base coordinates
Intended use: This function enables assigning physical coordinates corresponding to the current location of the
working bit of the machine to one of the G-codes within the following range: G50-G59.
Access path: Manual Mode [R] -> Configuration of coordinates -> List of base coordinates
Screen:
Course of action:
1) Select an axis (an appropriate G-code) to which you intend to assign the current value of a
corresponding physical coordinate.
o
The selected axis is displayed with an intersection, in relation to the edge of the column.
o
To navigate through the list of base coordinates, use the block of navigational keys (see Fig. 3). See
below to learn about the operations assigned to each of the keys:
[1] [↑] The cursor moves up to another item on the list;
[2] [↑] The cursor moves down to another item on the list;
[3] [↑] The cursor moves to the left item on the list;
[4] [↑] The cursor moves to the right item on the list.
2) Assign a value to the physical coordinate, by pressing [ENT].
o
The value set for the selected coordinate will change.
3) Declaration of coordinate for another axis – go back to item 1.
4) Confirm the declared coordinates, by pressing [F1] "Accept".
2.2.3 Physical coordinates
Intended use: This function enables changing values for each of the physical coordinates. Consequently, the
datum point corresponding to the global co-ordinate system is changed.
Access path: Manual Mode [R] -> Configuration of coordinates -> Physical coordinates
11
Advertisement
Table of Contents
