Table of Contents
Advertisement
Presented below is a program that carries out drilling to the depth of 2mm, including activating additional
functions and changing parameters:
%
G56
G90
G00 X0 Y0 Z0 A0
G92 a20 T200 t20 P1 z4 W1000 D3000 F9
G01 Z-1.9
G92 a5 T180 t18 P1 z4 F9
M35
G01 Z-2.0
G01 Z0
%
4 Automatic Working Mode
Intended use: This function carries out the travel of the working bit, according to a pre-defined path of
movement stored in the working program. When the machine is in operation, the name of the current
program in progress and the time elapsed from the beginning of drilling are displayed in the top right corner of
the screen (if the process is stopped, time is not counted).
Access path: Automatic Working Mode [A]
Screen:
Course of action:
1) Start PUMP1, PUMP2, PUMP3, GENERATOR.
2) Start the automatic working mode, by pressing: [F1]
o
If the operation is successful, the following messages will be displayed on the screen:
completed successfully.
The following keys are available, when this function is carried out:
[STOP]: Work is stopped. When the function is paused, GENERATOR is activated and the following
options for further actions will appear on the screen:
a.
[Fx] "Continue": Work will continue;
b. [Fx] "Abort": Work will be stopped.
[A]: Activation/Deactivation of the "Extended Working Mode" function (if already active, the following
message will be displayed: AUT ROZ). If the function is activated, the following error will be ignored:
"Error when returning to the beginning of segment";
[3]: Activation/Deactivation of the Burning Detection function (if already active, the following message
will be displayed: DET P).
[4]: Activation/Deactivation of the Electrode Vibration function (if already active, the following
message will be displayed: WIB);
[F2] "F-"; [F3] "F+": Reducing/Increasing the speed of moving the working bit of the machine along the
pre-set path of travel.
"
"
"
Start
.
"
Operation
24
Advertisement
Table of Contents
