TechniSat DIGITRADIO 602 Manual page 62

13 FM mode
13.1 Switching on the radio mode
> Press the MODE button as often as required until [UKW-Radio] appears on
the display.
Alternatively:
> Press the MENU button and then select [Main Menu > UKW].
When you switch on the radio for the first time, the frequency is set to 87.5
MHz.
If you have already set or saved a station, the radio plays the last station set.
In the case of RDS stations, the station name is displayed.
Adjust the antenna to improve reception.
13.2 FM reception with RDS information
RDS is a procedure for broadcasting additional information via FM stations.
Broadcasters with RDS might, for example, broadcast their station name or the
programme type. This appears on the display.
> The device can show the following RDS information:
RT (radio text),
PS (station name),
PTY (programme
type).
13.3 Manual station selection
> Press  or  in FM mode to set the desired station. The display shows the
frequency in increments of 0.05 MHz.
13.4 Automatic station selection
> Press SCAN to start the automatic scan. The station frequency runs upwards
in the display.
or
> In FM mode, hold down  or  for approx. 2 seconds to search
automatically for the next station with a strong enough signal.
If an FM station with sufficient signal intensity is found, the scan stops and
the
station is played. If an RDS station is being received, the station name is
displayed and, possibly, the radio text.
62