Safety Features; Cleaning And Maintenance - Hornbach 10530795 Operating Manual

Remarks:
• To check your settings, press the following sequence of buttons: DAY, EDIT, TIME/ON and
TIME/OFF. The settings appear on the display.
• The timer can be set to whole hours but not to minutes.
• TIME/OFF must always be later than TIME/ON.
• If the appliance is switched off at the main switch, if there is a power failure or if the plug is pulled
out, all settings are lost. Press SET to check the set day and time and to set them if necessary.
Switching the Open Window function on and off:
• Check that the appliance is on and is heating.
• Press
. The relevant symbol and °C appear on the display.
The default setting is 23°C. You can set your desired temperature using the plus and minus
buttons. If open window detection is active, the appliance will switch off and go into standby mode
if the temperature in the room falls by 5-10°C within ten minutes.
You can then switch the appliance back on with the ON/OFF button.
• To deactivate open window detection, press the
button again. The symbol disappears from
the display and the appliance resumes the previously set operation.
• If you activate open window detection while the appliance is operating in a preset week
programme, the open window detection will only function during the operating times that are set in
the programme.

Safety features

Overheating protection switches the appliance off if its interior becomes too hot. This can occur if
the appliance cannot fully expel all its heat or if too little fresh air is available for it to draw in.
The usual cause of this is that something is covering or partly covering the appliance or that the
air inlet or outlet is blocked or clogged.
If the overheating protection has interrupted operation, the appliance changes to fan only mode to
dissipate the heat. The display does not change.
Once the interior of the appliance has cooled, it resumes its set function. It is nevertheless
recommended that you switch the appliance off using the remote control and allow it plenty of time
to cool down.
Remove the cause of overheating and then start the appliance up normally. If you cannot identify
any cause for the overheating and if the problem persists, stop using the appliance and contact
your dealer.

Cleaning and maintenance

166