Hornbach 10530795 Operating Manual page 163

NOTE
The remote control unit only works when its sensor is aimed directly at the bathroom fan
heater.
The appliance must be in standby mode
(Check the display)
• Press the ON/OFF button
to switch the appliance on. The display
appears as in Fig. A.
• Now press the remote control function button
once to heat at half power.
The display appears as in Fig. B.
• Press a second time and the appliance heats at full power. The display appears
as in Fig. C.
• Press a third time and the appliance returns to Standby mode (see Fig. A.).
• The timer button
on the remote control functions in exactly the same way
as that on the appliance.
Setting the day and time:
• Press the SET button once: the display shows '12'.
Now use the plus and minus buttons / to set the hour of the current
time (0-23).
Press SET again to display the minutes. The display shows '30' and you can use
the plus and minus buttons to set the minutes of the current time (0-59).
Now press SET again. The display shows 'd7' (
); you can now use the plus and minus buttons
to set the day of the week as follows: Monday = d1, Tuesday = d2, etc.
Finally, press to confirm your settings. The display now resorts to what it was indicating
before you made the settings.
To check the day and time, press SET.
163