Hornbach 10530795 Operating Manual page 165

. The display shows the default value '00'. Press TIME/ON repeatedly to set the
5. Now press
start time (0-24), e.g. to 07:00, see Fig. G.
6. Now press . By default the display now shows the start time. Press TIME/OFF repeatedly
to set the end time (0-24), e.g. to 13:00, see Fig. G.
Note that the end time must always be later than the start time! If the two times are identical, the
appliance goes into standby mode.
7. Use the plus and minus buttons to set the required temperature.
8. While a value is flashing, you can change it or move to the next setting. If you wait too long, the
settings mode is cancelled.
9. Finally press OK to confirm your setting.
10. Repeat steps 2-7 to set a complete week-long programme of start and end times, offering
seven days with up to six operating periods per day.
11. To change a setting, go through the process described above and overwrite the current
values. Confirm with OK.
12. To deactivate the week timer, press the P button again. The 'P' disappears from the display
and the week programme is disabled. The appliance returns to its previous function.
NOTE
The week timer works in a continuous cycle, recommencing with day 1 after reaching day 7. If
you do not want this, deactivate the week timer using the P button.
165