Fisher & Paykel DH9060P Installation Manual/User Manual page 11

Heat pump clothes dryer
Hide thumbs Also See for DH9060P:
Table of Contents

Advertisement

Installation options
Your dryer can be installed one of two ways, either freestanding, or stacked on top
of a Fisher & Paykel front loading washer.
Free standing
1
The dryer stands on the floor and can easily be moved into position.
Stacking
2
Your dryer has been designed to be able to be stacked on top of any Fisher & Paykel
front loading washer. A stacking kit MUST BE USED between the products and fitted
correctly to the washing machine and dryer, as per the stacking kit instructions.
– Stacking Kit White: Part No. 428159. This Stacking kit is available from your
Fisher & Paykel dealer, online or from a Fisher & Paykel service technician.
Move the machine into the desired position. Do not lift the dryer by the top panel.
1
Have a minimum clearance on all sides of at least 20mm.
2
Install the machine on a stable and level floor (if not stacking on top of a front
3
loading washer).
Do not install your dryer in such a way that the dryer door cannot be opened fully.
z
Do not install the dryer outside, in a damp place, where there is a risk of freezing,
z
where it may be rained on, in direct sunlight or close to a source of heat.
Do not place your machine on top of its power cable.
z
Levelling the machine
It is IMPORTANT to level the machine to ensure the machine runs efficiently with
minimal noise. The dryer should be levelled in as close to its final position as possible
so it stands balanced evenly on all four feet. Ensure the dryer does not rock in
any direction.
The dryer comes with four adjustable feet. Wind all
four feet up or down until the dryer is correctly level.
A spirit level can assist with this process. The machine
is considered level when the bubble sits in the centre
(ie within the two lines or the circle), when the spirit level
is placed flat on top of your dryer, in the directions from:
left to right
1
back to front, and
2
corner to corner.
3
Never unscrew the feet completely from their housings.
Note: After levelling, the corners of the dryer cabinet should be clear of the floor
and the machine must not rock in any direction.
INSTALLATION INSTRUCTIONS
Levelling the feet
9

Advertisement

Table of Contents
loading

Table of Contents