Table of Contents
Advertisement
ADJUSTMENTS
TAIL WHEEL
The tail wheel is located at the right rear of the merger. Located on the tail wheel pivot spindle is an
adjustable brake assembly. Adjust brake by tightening bolt (A). The brake should have enough tension to
prevent zig-zag motion, but still allow the wheel to pivot when making corners. Improper adjustment will
cause severe tire wear and damage to Merger.
A
PICKUP ADJUSTMENTS
1. Pickup belts are adjusted by adjusting the take up bolt (B) located on both ends of the pickup bottom
roller. The bearing bracket bolts (C) must be loosened before adjustment, and tightened after the desired
belt tension is attained. Proper belt tension will be achieved when 1.5'' of slack can be pulled in the cen-
ter of the belts with minimal resistance. DO NOT tighten pickup belts excessively. Over-
tightening may cause damage to belts or rollers. Loose belts will cause unnecessary tooth wear and
breakage.
C
B
(Behind Gauge Wheel)
-11-
Advertisement
Table of Contents
