How To Attend To A Fault - Fisher & Paykel DishDrawer DD60SA User Manual

If it's a 'A' code
A1: Ensure the water supply is
on, press
fault then press
the wash program.
A3: Ensure the drainage hose
and connection to pipes are not
blocked. Press
fault then press
the wash program.
A09:
(DD***C models only)
the water supply is on. Press
to clear the fault, then run the
sanitize cycle again.
A6: Open the drawer and
check the spray arm.
Has the spray arm loosened
or come off its mounting?
YES
Refit the spray arm
following instructions in
section 'User maintenance
instructions', then close
the drawer, press
then press to resume the
wash program.
Has the fault code disappeared?
Has the dishwasher resumed
normal operation?
You have corrected the fault
and can continue to use your
dishwasher as normal.
40

HOW TO ATTEND TO A FAULT

START HERE
Press to stop the beeping.
Note down the fault code.
Look up the fault in the
table opposite.
again to clear the
to resume
to clear the
to resume
: Ensure
NO
again,
YES
Press
then press
Has the fault code disappeared?
Disconnect the dishwasher from the
NO
power supply (unplug or switch off
at circuit breaker), turn off its water
supply, then contact Customer Care
with the fault code information. See
your 'Service and warranty' booklet
for contact details.
If it's an 'F' code
. Wait a few seconds,
again.
The fault has
reset. You can
continue to use
your dishwasher.
NO
YES