Fisher & Paykel DishDrawer DD60SA User Manual page 15

SETTING WASH MODIFIERS
Using sanitize
The sanitize wash modifier adjusts the wash program to meet the conditions required by
Section 6, NSF 184 for sanitization to occur.
While sanitize is running, the wash program is monitored to ensure that these conditions
are met.
IMPORTANT!
Only cycles utilising the sanitize wash modifier are designed to meet the conditions
●
required by Section 6, NSF 184. Other wash programs may not reach the temperatures
required for sanitization to occur. See table on previous page for wash programs that
have sanitize available.
For sanitization to occur, the temperature of the water needs to reach 70
●
Check that all items are 'dishwasher safe' before running the sanitize modifier.
If the wash is interrupted or the water supply is turned off during the cycle, then the
●
heating conditions for sanitization may not be met. You may need to run the cycle
again to ensure sanitization of your dishes.
At the end of a wash programme with sanitize, always check the display to make sure
that sanitization has been successful.
If sanitization has been successful:
The dishwasher will beep
●
0
will show in the display
●
The sanitize indicator will remain lit.
●
After 30 seconds the display will turn off.
●
If sanitization has not been successful:
An alert will sound
●
An alert code will show in the display
●
The sanitize indicator will not be lit.
●
Check if the water supply has been turned
●
off or the wash cycle interrupted.
Press to clear the alert code,
●
then run the sanitize cycle again.
See also section 'How to attend to a fault'.
●
(DD***C MODELS ONLY)
0 0
C/158 F.
11