Attaching The Cable Guide; Wall-Mounting - Cisco CATALYST 2960 Hardware Installation Manual

Chapter 2 Switch Installation (24- and 48-Port Switches)

Attaching the Cable Guide

We recommend that you attach the cable guide to prevent the cables from obscuring the front panel of
the switch and the other devices installed in the rack. Use the supplied black screw shown in
to attach the cable guide to the left or right bracket.
Figure 2-9 Attaching the Cable Guide on the Catalyst 2960 Switch
1
1

Wall-Mounting

This section does not apply to the Catalyst 2960 8-port switches. For information applicable to those
switches, see
To install the switch on a wall, follow the instructions in these sections:
•
•
•
OL-7075-09
SYS T
RPS
STAT
DUP LX
SPE ED
MOD E
Cable guide screw
Chapter 3, "Switch Installation (8-Port Switches)."
Attaching the Brackets to the Switch for Wall-Mounting, page 2-12
Attaching the RPS Connector Cover, page 2-12
Mounting the Switch on a Wall, page 2-13
Catalyst 2960 Switch Hardware Installation Guide
Installing the Switch
Figure 2-9
2-11