Attaching The Brackets To The Switch For Wall-Mounting; Attaching The Rps Connector Cover - Cisco CATALYST 2960 Hardware Installation Manual

Installing the Switch

Attaching the Brackets to the Switch for Wall-Mounting

Figure 2-10
attach the second bracket to the opposite side.
Figure 2-10
1X
1

Attaching the RPS Connector Cover

If your switch has an RPS connector and you are not using an RPS with your switch, use the two Phillips
pan-head screws to attach the RPS connector cover to the back of the switch, as shown in
The Catalyst 2960 8-port switches and the Catalyst 2960-24-S, 2960-24TC-S, 2960-48TT-S, and
Note
2960-48TC-S switches do not have an RPS connector.
If an RPS is not connected to the switch, install an RPS connector cover on the back of the switch.
Warning
Statement 265
Figure 2-11
1
1
2
Catalyst 2960 Switch Hardware Installation Guide
2-12
shows how to attach a 19-inch bracket to one side of the switch. Follow the same steps to
Attaching the 19-inch Brackets for Wall-Mounting
11X
Phillips truss-head screws
Attaching the RPS Connector Cover on the Catalyst 2960 Switch
CO NS OL
E
2
Phillips pan-head screws
RPS connector cover
Chapter 2
3
3
RPS connector
Switch Installation (24- and 48-Port Switches)
1
Figure 2-11.
OL-7075-09