Magnet Mounting - Cisco CATALYST 2960 Hardware Installation Manual

Installing the Switch

Magnet Mounting

This section is specific to the Catalyst 2960 8-port switches. For information applicable to the other
Catalyst 2960 switches, see
Place one side of the magnet against the bottom of the switch, as shown in
Step 1
Figure 3-7
2
1
2
Mount the magnet and switch on a metal surface.
Step 2
After the switch is attached to the mounting magnet, do these tasks to complete the installation:
1.
2.
3.
For configuration instructions about using the CLI setup program, go to
Switch with the CLI-Based Setup Program."
Catalyst 2960 Switch Hardware Installation Guide
3-14
Chapter 2, "Switch Installation (24- and 48-Port Switches)."
Mounting the Switch with a Magnet
1
1
es
eri S 60
29
t
ys
al at 8x
C
7x
6x
5x
4x
3
Metal surface 3 Switch
Magnet
Power on the switch. See the
Connect to a 10/100 or 10/100/1000 port, and run Express Setup. See the switch getting started guide
for instructions.
Connect to the front-panel ports. See the
on page 2-14, the "Connecting to SFP Modules" section on page
Dual-Purpose Port" section on page 2-20
3x
2x
D SP
1x E
L O
S LX
N O DP
C
T
STA
ST
SY
"Verifying Switch Operation" section on page
"Connecting to the 10/100 and 10/100/1000 Ports" section
to complete the installation.
Chapter 3 Switch Installation (8-Port Switches)
Figure 3-7.
3-5.
2-18, and the "Connecting to a
Appendix C, "Configuring the
OL-7075-09