Cisco CATALYST 2960 Hardware Installation Manual page 17

Chapter 1 Product Overview
The Catalyst 2960-24TC-L and Catalyst 2960-48TC-L switches have dual-purpose ports, that is,
10/100/1000 ports 1 and 2 can use either the SFP module or the RJ-45 connector for that port, but not
both. Use the software to set the connector type for these ports. For more information about the
dual-purpose port, see the
Figure 1-8
1 10/100 ports 2
Figure 1-9
1 10/100 ports 2
The Catalyst 2960-24LT-L, Catalyst 2960-24TT-L, and Catalyst 2960-48TT-L switches have two
10/100/1000 uplink ports, numbered 1 and 2. Ports 1 to 8 on the Catalyst 2960-24LT-L switch are PoE
ports. See
Figure 1-10
SYST
RPS
STAT
DUPLX
SPEED
PoE
MODE
1 10/100 PoE ports
2 10/100 ports
Figure 1-11
1 10/100 ports 2
OL-7075-09
"Dual-Purpose Port" section on page
Catalyst 2960-24TC-L Switch Front Panel
Dual-purpose ports
Catalyst 2960-48TC-L Switch Front Panel
1
Dual-purpose ports
Figure 1-10, Figure 1-11, and
Catalyst 2960-24LT-L Switch Front Panel
3 10/100/1000 uplink ports
Catalyst 2960-24TT-L Switch Front Panel
10/100/1000 uplink ports
1
Figure 1-12.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19
1X 1X 11X 13X
12X 14X
2X 2X
POWER OVER ETHERNET
1 2
1
Catalyst 2960 Switch Hardware Installation Guide
Front Panel Description
1-13. See Figure 1-8 and Figure
2
2
Catalyst 2960 Series PoE-8
20 21 22 23 24
23X
1 2
24X
3
2
1-9.
1-7