Table of Contents
Advertisement
14
SUNSTAR传感与控制 http://www.sensor-ic.com/ TEL:0755-83376549 FAX:0755-83376182 E-MAIL:szss20@163.com
Do not use less than the starting torques M
overleaf, which should be routed through the transducer, in non-positive
contact.
When locking, make sure that the transducer signal changes by no more than
0.1%.
In the case of transducers with nominal forces 20kN..100kN, you can also
lock as follows for tensile loading:
• screw in knuckle eyes
• load transducer with 10..20% of the nominal force
• tighten the lock nut of the lower knuckle eye
Static loading can also – in addition to using knuckle eyes – be carried
axially to the transducer through hardened (40...44HRc) pressure plates that
have been given a plane-parallel surface. The transducer support structure
must also have an inflexible, hardened and plane-parallel surface. We
recommend ZDK compressive force introduction parts for standard
measurements in industry.
Type
Z4A/20kN
Z4A/50kN
Z4A/100kN
Z4A/200kN
Z4A/500kN
SUNSTAR自动化 http://www.sensor-ic.com/ TEL: 0755-83376489 FAX:0755-83376182 E-MAIL:szss20@163.com
ZDK compressive force introduction accessories
ZDK accessories
Z4A/20kN/ZDK
Z4A/50kN/ZDK
Z4A/100kN/ZDK
Z4A/200kN/ZDK
Z4A/500kN/ZDK
recommended in the table
A
∅ D
Weight [kg]
0.10
0.18
0.40
1.26
5.80
Z4A
–0.1
∅
B
D
Z
–0.3
99
20
111
25
140
36
200
50
365
80
HBM 20.11.00
Advertisement
Table of Contents
