Configuring Isdn Pri Country Parameters - Nortel IVR 2.5/S Manual

Configuring ISDN PRI country parameters

Note: The examples in the following procedure are based on the
Enhanced DPNSS PRI signaling option.
Procedure 4-5: Configuring country parameters for the ISDN PRI
signaling option
1 At the /sci/install> prompt, type country.
The system displays the copyright information for the Nortel
Internationalization utility.
2 When prompted, press <Enter> to continue.
The system displays the present country configuration, followed by this
prompt:
Do you wish to change the country parameters? [y/n]:
3 Type y to change the current country configuration and press <Enter>.
The system displays this prompt:
Are you using an ACL E1 network card? [y/n]:
4 Type y and press <Enter> to continue.
The system displays this prompt:
Please enter the number of trunks on your network
card? 30 or 60 []:
If you installed an ACL-30 E1 card, enter 30. If you installed an ACL-60
E1 card, enter 60.
5 Press <Enter> to continue.
The system displays a list of countries and signaling protocols.
Note: Implementation of a country's regulatory requirements may
require additional hardware in order to adhere to the network
requirements of a specific country.
Nortel IVR 2.5/S
Installing the Aculab E1/PRI signaling option 4-13
Aculab-Based E1 CAS/ISDN PRI Signaling Guide