Activating The Signaling Option - Nortel IVR 2.5/S Manual

Activating the signaling option

19 If this is a new installation or a restoration of the signaling option, then
you must activate the signaling option as described in "Activating the
signaling option" on page 4-17. If this is part of an upgrade from
Release 2.01/S to 2.5/S, then it is not necessary to activate the feature.
After the signaling option components (hardware and software) are installed,
the option must be activated. Contact your Nortel service provider for
assistance. Make sure the modem is connected to the system for remote login,
as described in Appendix A.
Nortel IVR 2.5/S
Installing the Aculab E1/PRI signaling option 4-17
Aculab-Based E1 CAS/ISDN PRI Signaling Guide