Installing The Aculab E1/Pri Signaling Option - Nortel IVR 2.5/S Manual

Chapter 4: Installing the Aculab E1/PRI
signaling option
Before installing this option, your MRS system must have MRS version
3.02.02 installed. The base Nortel IVR 2.5/S system includes MRS 3.02.02
software, so it should already be installed on your MRS.
This chapter describes how to install the Aculab-based E1/PRI Signaling
option hardware and software onto your MRS system. It also shows you how
to configure the SCI country parameters for your desired signaling option.
The installation is divided into three main steps:
1 installing the signaling option hardware
2 installing the signaling option software (for CAS or ISDN)
3 configuring the country parameters (for CAS or ISDN)
Nortel IVR 2.5/S Aculab-Based E1 CAS/ISDN PRI Signaling Guide
4-1