Install new ECM fasteners to secure
▼
the ECM unit. Tighten to 89 lbf in
(10 Nm).
Reconnect the three connectors to
▼
the ECM unit.
Reconnect the accessory connector.
▼
Secure the accessory connector
cable into the ECM cable clips.
Reconnect the battery, positive (red)
▼
lead first and then the negative
(black) lead.
Tighten the battery terminals to
▼
40 lbf in (4.5 Nm).
Apply a light coat of grease to the
▼
terminals to prevent corrosion.
Cover the positive terminal with the
▼
protective cap.
Reinstall the seat (see page 71).
▼
Speed Twin 1200 and Thruxton RS Only
To install the battery:
Place the battery in the battery
▼
case.
Secure with the battery strap and
▼
make sure the USB port socket is
reinstalled.
Reconnect the battery, positive (red)
▼
lead first and then the negative
(black) lead.
Tighten the battery terminals to
▼
40 lbf in (4.5 Nm).
Apply a light coat of grease to the
▼
terminals to prevent corrosion.
Cover the positive terminal with the
▼
protective cap.
Reinstall the seat (see page 71).
▼
MAINTENANCE AND ADJUSTMENT
Fuses
Always replace blown fuses with new
ones of the correct rating (as specified
on the fuse box cover).
Never replace a blown fuse with a fuse
of a different rating.
Use of an incorrect fuse could lead
to an electrical problem, resulting in
motorcycle damage, loss of motorcycle
control and an accident.
Note
A blown fuse is indicated when all of the
systems protected by that fuse become
inoperative. When checking for a blown
fuse, use the table to establish which
fuse has blown.
Warning
141