Cruise Control (If Equipped); Activating Cruise Control - Triumph Bonneville T100 Owner's Handbook Manual

Cruise Control (if equipped)

Warning
Cruise control must only be used
where you can ride safely at a steady
speed.
Cruise control should not be used
when riding in heavy traffic, on roads
with sharp/blind bends or when they
are slippery.
Using cruise control in heavy traffic,
on roads with sharp/blind bends or
when they are slippery, may result
in loss of motorcycle control and an
accident.
Warning
This Triumph motorcycle should be
operated within the legal speed limits
for the particular road traveled.
Operating a motorcycle at high speeds
can be potentially dangerous since the
time available to react to given traffic
situations is greatly reduced as road
speed increases.
Always reduce speed in potentially
hazardous driving conditions such as
bad weather or heavy traffic.
GENERAL INFORMATION
The cruise control button is located on
the left hand switch housing and can
be operated with minimum movement
when riding.
1. Cruise control button
Cruise control can be switched on or off
at any time but it cannot be activated
until all the conditions described on
page 49 have been met.

Activating Cruise Control

The following conditions must be met to
activate cruise control:
The motorcycle must be traveling at
▼
a speed between 19 to 100 mph (30
to 160 km/h).
The motorcycle must be in 3
▼
or higher.
To activate cruise control:
Press the cruise control button to
▼
turn the cruise control system on.
The cruise control symbol will be
shown in the display screen.
When the required cruising speed
▼
is achieved, press the cruise control
button again to activate the cruise
control. The cruise control light
in the tachometer will illuminate
indicating that the cruise control is
active.
49
1
gear
rd