The cleaner can be carried by
placing hand under the carrying
handle and lifting.
Stand on one end of rug and move
cleaner toward other end. Before
reaching edge, push down on handle.
This will lift up the nozzle and will pre-
vent the rug from clinging to the cleaner.
Continue to lift up nozzle so that when
you have reached the edge, it is com-
pletely off the rug. Move cleaner back to
start again, lower nozzle, and use only
The handle of your cleaner has
three positions: upright for storage
and for when using cleaning tools; oper-
ating position for general operation on
carpets and floors; low for reaching
under low furniture. Step on handle
release pedal (E), then pull handle back
to lower handle.
Special edge groomers are provid-
ed on both sides of the front of the
cleaner to remove dirt in carpet near
baseboards and furniture.
Guide either side parallel to the edge of
carpet or furniture.
feature (some models)
With red and green lights, the
DirtFINDER™ system alerts the
user to areas of carpet that may need
more cleaning attention. It is able to
sense when embedded dirt is removed.
The clean light (green) will remain on
throughout cleaning except when the
detector senses that a larger amount of
dirt is being picked up; then the dirty
light (red) will come on.
When the dirty light is on, you should
take additional cleaning strokes in the
area until it changes to clean.