Upright Vacuum Cleaner HOOVER Thank you for your purchase! This product was designed for easy assembly (see page 3) Owner’s Manual ENGLISH pp.1-12 ESPAÑOL pág. 14-21 FRANÇAIS p. 23-30 ®...
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot).
If you need any assistance: Visit our website at www.hoover.com. Click on the “Service” button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) Call 1-330-499-9499 to speak with a representative in our Consumer Response Center.
Push screws into holes on back of handle (Fig. 1-6) and hose holder (Fig. 1-7). Tighten screws securely with a Phillips screwdriver. 2. How to use Cleaner description Polarized plug To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other).
Transporting cleaner Put handle in upright position. Tilt clean- er back on rear wheels. Push forward. Carpet height adjustment The cleaning of carpet and rugs takes place at the nozzle (C). When it is necessary to raise and lower the nozzle for various carpet pile heights, slide the nozzle control knob (D) to the desired setting.
Cleaning tools When using cleaning tools, cleaner han- dle should be in the upright position to activate the automatic “brush roll OFF” and for convenience in moving the cleaner from one area to another. 2-11 Turn cleaner OFF before disconnect- ing and connecting hose to hose tube (E).
3. Maintenance Familiarize yourself with these home maintenance tasks. Proper use and care of your cleaner will ensure continued cleaning effectiveness. Dirt cup The dirt cup assembly consists of the following parts: Lid (A) Dirt Cup (B) Pre-filter (C) HEPA Cartridge Filter (D) Dirt Opening (E) Handle (F) While the cleaner is in operation, the pre-...
Let filter air dry and reposition it. Replace door. Snap closed. Should you want to replace this filter, ask for HOOVER part No. 40110009. Do not operate cleaner without the fil- ter in place. Grasp end of HEPA cartridge filter and pull it away from pre-filter.
Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, HOOVER part No. 27313107. 3-15 Replace lens - Place one tab (L) on lens into slot. Press on lens and secure other tab. 3-18 Insert screwdriver between latch (N) and bottom plate (O).
Turn agitator, to make sure it rotates freely. Replace and tighten screws. Replace belt When replacing belt, ask for HOOVER part No. 38528037. 1. Remove bottom plate, belt guard and brush roll as described in Figs. 3-21 through 3-23.
(see “Service” section). Hoover Cleaning Performance This Hoover Cleaning Performance Sys- tem is for comparing the relative pro- gressive performance of Hoover uprights only and not for comparison with any other brands. The majority of...
• calling 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only). Do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay. If further assistance is needed, contact...