× Bookmark added
Page of 13


-_ pp.1-12
'_, pag. 14-21
'_' p. 23-30
you for
your purchase!
This product was designed for
easy assembly (see page 3)


   Related Manuals for Hoover SAVVY U8135-900

   Summary of Contents for Hoover SAVVY U8135-900

  • Page 1

    Upright Vacuum Cleaner by HOOVER Owner's Manual ENGLISH -_ pp.1-12 ESPANOL '_, pag. 14-21 FRANGAIS '_' p. 23-30 Thank you for your purchase! This product was designed for www.hoover.com easy assembly (see page 3)

  • Page 2

    Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot). © 2004 The Hoover Company...

  • Page 3

    If you need any assistance: Visit our website at www.hoover.com. Click on the "Service" button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) Call 1-330-499-9499 to speak with a representative in our Consumer Response Center.

  • Page 4

    l _, Push screws into holes on back of Place hose on holder. Remove label (C) from Custom Control switch. handle (Fig. 1-6) and hose holder (Fig. 1-7). If label has come off during Tighten screws securely with a assembly, make sure switch is in Phillips screwdriver.

  • Page 5

    p_,€! Handle positions Transporting cleaner Carrying cleaner Put handle in upright position. Tilt clean- The handle of your cleaner has three Use the carrying handle to lift the er back on rear wheels. Push forward. cleaner. positions; upright for storage and when using cleaning tools;...

  • Page 6

    Cleaning tools When using cleaning tools, cleaner han- dle should be in the upright position to activate the automatic "brush roll OFF" and for convenience in moving the cleaner from one area to another. Select proper tool Attach wand and tools F.

  • Page 7

    When to empty to empty We recommend that the dirt cup be Familiarize yourself with these home emptied before the dirt reaches the dirt maintenance tasks. Proper useandcare opening on back of cup (Fig. 3-1 ) or after ofyour c leaner will e nsure c ontinued every use if you prefer.

  • Page 8

    Turn knob on Replace door. Snap closed. lid until lid closes (Fig. 3-3). Should you want to replace this filter, ask for HOOVER part No. 40110009. Do not operate cleaner without the fil- ter in place.

  • Page 9

    Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, HOOVER part No. 27313107. Remove lens - Disconnect cleaner Install bulb - Pull old bulb straight out from electrical outlet. of socket. Push new bulb straight into...

  • Page 10

    Replace and tighten screws. Pivot bottom plate down and snap closed. Powered hand tool Replace belt When replacing belt, ask for HOOVER Belt replacement part No. 38528037. Inspect belt 1. Remove bottom plate, belt guard and The powered hand tool belt is designed brush roll as described in Figs.

  • Page 11

    • Too much pressure being applied to • Incorrect carpet height setting tool • Move nozzle control knob to lower • Continue using tool applying light This Hoover Cleaning Performance Sys- setting pressure. • Blockage in air flow passage tem is for comparing the relative pro- •...

  • Page 12

    (U.S. only). If further assistance is needed, or if there are questions concerning this Do not send your cleaner to The Hoover warranty or the availability of warranty Company in North Canton for service, service outlets, write or phone the this will only result in delay.

Comments to this Manuals

Symbols: 0
Latest comments: