× Bookmark added
Page of 13
Download

Advertisement

Upright
Vacuum
Cleaner
by HOOVER
Owner's
Manual
ENGLISH
-) pp.1-12
ESPAIC, IOL ,,_ pag. 14-21
FRAN(_AIS ,,_ p. 23-30
Thank
you for
your purchase!
www.hoover.com
This product was designed
for
easy assembly
(see page 3)

Advertisement

   Related Manuals for Hoover SAVVY U8161-900

   Summary of Contents for Hoover SAVVY U8161-900

  • Page 1

    Upright Vacuum Cleaner by HOOVER Owner's Manual ENGLISH -) pp.1-12 ESPAIC, IOL ,,_ pag. 14-21 FRAN(_AIS ,,_ p. 23-30 Thank you for your purchase! This product was designed www.hoover.com easy assembly (see page 3)

  • Page 2

    • Do not use with damaged cord or plug. if appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot).

  • Page 3

    If you need any assistance: Visit our website at www.hoover.com. Click on the "Service" button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) Call 1-330-499-9499 to speak with a representative...

  • Page 4

    Push screws into holes on back of Place hose on holder. Remove label (C) from Custom Control switch. handle (Fig. 1-6) and hose holder (Fig. 1-7). If label has come off during Tighten screws securely with a assembly, make sure switch is in Phillips screwdriver.

  • Page 5

    Handle positions Transporting cleaner Carrying cleaner Put handle in upright position. Tilt clean- The handle of your cleaner has three Use the carrying handle to lift the er back on rear wheels. Push forward. cleaner. positions; upright for storage and when using cleaning tools;...

  • Page 6

    Cleaning tools When using cleaning tools, cleaner han- dle should be in the upright position _I_'__ to activate the automatic "brush roll OFF" and for convenience in moving the cleaner from one area to another. Attach wand and tools Select proper tool F.

  • Page 7

    to empty When to empty We recommend that the dirt cup be Familiarize yourself withthese home emptied before the dirt reaches the dirt maintenance tasks. Proper useandcare opening on back of cup (Fig. 3-1) or after ofyourcleaner willensure c ontinued every use if you prefer.

  • Page 8

    Turn knob on Replace door. Snap closed. lid until lid closes (Fig. 3-3). Should you want to replace this filter, ask for HOOVER part No. 40110009. Do not operate cleaner without the fil- ter in place.

  • Page 9

    Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, HOOVER part No. 27313107. Remove lens - Disconnect cleaner Install bulb - Pull old bulb straight out of socket. Push new bulb straight into from electrical outlet.

  • Page 10

    When agitator brushes are worn, the brush roll should be replaced. Ask for HOOVER part No. 48414088. 3. Remove agitator including end plates 2. Unscrew the two Phillips screws and (C) and discard. remove belt guard (B).

  • Page 11

    • Incorrect carpet height setting tool Performance • Move nozzle control knob to lower • Continue using tool applying light This Hoover Cleaning Performance Sys- setting pressure. • Blockage in air flow passage tem is for comparing the relative pro- •...

  • Page 12

    (U.S. only). If further assistance is needed, or if there are questions concerning this Do not send your cleaner to The Hoover warranty or the availability of warranty Company in North Canton for service, service outlets, write or phone the this will only result in delay.

Comments to this Manuals

Symbols: 0
Latest comments: