Infopia EASYGLUCO Auto-coding Operation Manual page 14

Testing Procedure
Testing Your Blood - Case of activated User Activity option and User
ID option
Step 4-1
If you selected to use the User Activity option
during set up, press up and down button to select
the activity that correlates with your result (refer
to p10), then press
If you do not select to use user activity option
during set up, press
Step 4-2
If you selected to use the User ID option during
setup, press
User ID, then press
caution
1. If you did not activate the User Activity option and/or the User ID option, Step 4-1
and/or Step 4-2 procedures are not conducted.
2. Although User Activity option and/or User ID option are activated, if you pull the
test strip out right after the test, you can not move onto step 4, The test result is
stored, not under a specific User ID and only displayed after deactivating the
User Id option.
3. Please refer to page 13, if you want to set the User Activity option and User ID
option.
26
.
to continue to step 4-2.
button to select the correct
and
.
1. After checking your test result, slide the ejector button twice forward to
remove the test strip from the meter.
2. Discard the used strip and lancet to a proper place, according to the local
regulation.
1. Once the test is complete, pull the Blood glucose test strip forward to remove
the Blood glucose test strip from the
cose test meter.
2. Dispose of used Blood glucose test strip in a sealed container with your
household waste in acordance with local regulations
Caution
1. If you push the ejector button forward too much, it may be part of the failure.
2. Do not give strong impact to blood glucose test meter.
Test strip ejector function
Blood glu-
EASYGLUCO Auto-coding
TM
27