Output Signal Phase (Phase); Channels Swap (Ch Swap); Low-Pass Filter (Lp Filter); High-Pass Filter (Hp Filter) - M2TECH EVO PHONODAC TWO User Manual

EVO PHONODAC TWO
DXD-DSD A-TO-D AND D-TO-A CONVERTER – PHONO PREAMP
REVISION P A – JULY 2016
R
• MUTED: at power on, the EVO PHONODAC TWO S/PDIF sets the output volume to
zero (complete mute).

8.4. Output signal phase (PHASE)

This item also relates to 3 values:
• BACK: go to level 1;
• INVERTED: the output signal's polarity will be inverted;
• NORMAL: the output signal's polarity will NOT be inverted.

8.5. Channels swap (CH SWAP)

This item also relates to 3 values:
• BACK: go to level 1;
• YES: left and right channel signals will be swapped at output connectors (left
channel sent to right connector and right channel sent to left connector);
• NO: left and right channel signals will be sent to their related output connectors.

8.6. Low-pass filter (LP FILTER)

This item relates to 4 values:
• BACK: go to level 1;
• 5KHZ: frequencies above 5kHz will be cut off;
• 10KHZ: frequencies above 10kHz will be cut off;
• OFF: signal is passed without high frequency cut.

8.7. High-pass filter (HP FILTER)

This item relates to 6 values:
• BACK: go to level 1;
• 120HZ: frequencies below 120Hz will be cut off;
• 60HZ: frequencies above 60Hz will be cut off;
• 15HZ: frequencies above 15Hz will be cut off (IEC compliancy);
• 1HZ: frequencies above 1Hz will be cut off;
• OFF: signal is passed without low frequency cut.

8.8. MPX filter (MPX FLT)

24
M2Tech
www.m2tech.biz
Copyright © 2016, M2Tech Srl