Table of Contents
Advertisement
Wartungs- und Reparaturanleitung
Maintenance and Repair Instruction
Disassembly:
Remove the closing cap (16).
Remove the spring pin (17).
Hold the spindle nut (18) in place and rotate the spindle (19) in order to remove it along with the
cog wheel (20).
Remove the distance tube (21) and the spindle nut (18) along with the connecting rod (22).
Separate the spindle nut (18) from the connecting rod (22).
If necessary the 2 bearing sleeves (23) can also be replaced at this stage.
Assemble in reverse order.
Please note:
To ensure parallel positioning pay attention to the following order of assembly:
The drive tube (7) is to be installed after all the other parts of the gear are in place.
When the drive tube (7) has been positioned, connect it to the shaft (13) at one side only.
Now both sides must be rotated up to the upper stop.
Then the remaining side of the drive tube (7) can also be connected to the shaft (13).
If necessary the drive tube (7) must be rotated somewhat towards the next fixing hole of
the shaft (13).
All gear parts must be lubricated with Molykote DX white (Mat.No. 5822.0040)
Carry out a functional test.
1118.0XGB_ 06
Alphaclassic / Betaclassic
1118
Page: 48
Advertisement
Table of Contents
