Topics:
•
Remove filler panels
•
Install an ES40 shelf into the rack
•
Install a DS60 shelf into the rack
•
Install an FS25 shelf into the rack
Remove filler panels
The front space of the rack into which you will install the shelf is usually covered by a filler panel. If one or more filler panels
cover the space where you want to install the shelf, use this procedure to remove each panel.
Steps
1. On the filler panel, slide the left and right securing tabs to the open position (towards the center of the panel).
2. Remove the filler panel from the cabinet.
Install an ES40 shelf into the rack
Follow the steps in this section to install the rails, ES40 expansion shelf, and bezel. Follow these steps for each ES40 shelf you
are installing.
Installing the rails in the cabinet
About this task
The rails are compatible with racks with square holes, unthreaded round holes, and threaded round holes.
NOTE:
The front edge of each rail is stamped L or R for left or right side with the rail facing the cabinet front.
Install each rail in the cabinet.
Steps
1. From the front of the cabinet, insert the rail alignment pins above and below the bottom U mark on the rear cabinet channel.
30
Install the Disk Shelves in the Rack
Install the Disk Shelves in the Rack
3