Table of Contents
Advertisement
Figure 95. Installing a disk
8. Repeat steps 1-7 to add the remaining 14 disks.
Close the shelf chassis
About this task
After installing all 15 new disks, close the DS60 chassis.
Steps
1. Using the orange shelf latch handles, push the shelf slowly into the cabinet. Be aware of SAS and Power cabling as the shelf
is reseated.
2. Screw the shoulder-screws in until they are seated.
3. Screw the attaching screws to the NEMA channel.
Verify and configure the new disks
About this task
Complete the following tasks to verify and configure the new disks.
Steps
1. Run the filesys enable to command to reenable the file system.
2. Run the enclosure show summary command to verify the Data Domain system recognizes the new disk shelf.
NOTE:
This step is not required when adding a new disk pack to an existing DS60.
● For a new DS60:
# enclosure show summary
Enclosure Model No. Serial No.
--------- --------- --------------- ------ -------- --------- --------
1
DD####
2
DS60
3
DS60
--------- --------- --------------- ------ -------- --------- --------
3 enclosures present.
● For a new ES40:
# enclosure show summary
Enclosure Model No. Serial No.
--------- --------- --------------- ------ -------- --------- --------
1
DD####
2
ES40
State
<Serial#>
Online
<Serial#>
Online
<Serial#>
Online
State
<Serial#>
Online
<Serial#>
Online
OEM Name OEM Value Capacity
4 Slots
60 Slots
60 Slots
OEM Name OEM Value Capacity
4 Slots
15 Slots
Add Storage Capacity
99
Advertisement
Table of Contents
