Table of Contents
Advertisement
Figure 4. Adjusting the lift arm bar to just under 17 inches
Reconfiguring the lift with the Voyager kit
About this task
If you are using the Alum-A-Lift to install or remove components above 49 inches (28U) from the floor, use the single (lower)
mast configuration with the Voyager conversion kit and support table.
Refer to the following figure while performing this task.
Steps
1. Unpack the Voyager kit.
2. Use the instructions provided within the kit to reconfigure the lift.
14
Introduction and Preparation
1
2
<17"
CL4900
Advertisement
Table of Contents
