Table of Contents
Advertisement
Figure 2. Adjusting the lift arm bar to just under 17 inches
Reconfiguring the lift with the Voyager kit
About this task
If you are using the Alum-A-Lift to install or remove components above 49 inches (28U) from the floor, use the single (lower)
mast configuration with the Voyager conversion kit and support table.
Steps
1. Unpack the Voyager kit.
2. Use the instructions provided within the kit to reconfigure the lift.
1
2
<17"
CL4900
Introduction and Preparation
11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Data Domain DD6800 and is the answer not in the manual?
Questions and answers