Cisco GRP= Installation And Configuration Note page 38

Implementing Additional Configuration and Maintenance Tasks
The following formatting procedure erases all information on the Flash memory card or Flash disk.
Caution
To prevent the loss of important data that might be stored on a Flash memory card or Flash disk,
proceed carefully. If you want to save the data on a Flash memory card or Flash disk, copy the data
to a server before you format the card.
To format a new Flash memory card or Flash disk, follow these steps:
The flash card command examples presented in this publication assume the use of a standard linear
Note
Flash memory card. If you are using an ATA Flash disk, replace any commands with either the slot0:
or slot1: command argument with a disk0: or disk1: command argument.
After booting your router, insert the Flash memory card or Flash disk into slot 0. (Use the procedure in
Step 1
the "Installing and Removing Flash Memory Card or Flash Disk in GRP" section on page
is not available, use slot 1.
Step 2 Enter the format slot0: (or format slot1:) command as follows:
Router# format slot0:
All sectors will be erased, proceed? [confirm]
Enter volume id (up to 30 characters): NewCard
Formatting sector 1
Format device slot0 completed
Router#
Note
The new Flash memory card or Flash disk is now formatted and ready to use.
For complete command descriptions and configuration information, refer to the Configuration
Fundamentals Command Reference, the Configuration Fundamentals Configuration Guide, and the
Cisco 12000 Series Internet Router Flash Disk Information publications. (For information on obtaining
these publications, see the
Flash Disks and Flash Memory Cards in the GRP
38
For this example, a 20-MB Flash memory card was used. At the line "Formatting sector," the
system counts backward from 160 to 1.
"Obtaining Documentation" section on page
35.) If slot 0
53.)
78-4339-09