Cisco GRP= Installation And Configuration Note page 36

Implementing Additional Configuration and Maintenance Tasks
Figure 14
Both slots can be used at the same time. Use the following procedure to install a Flash memory card or
Flash disk:
Facing the GRP front panel, hold the Flash memory card or Flash disk with the connector end of the
Step 1
card toward the slot and the label facing right. (See
Note
Insert the card into the appropriate slot until the card completely seats in the connector at the back of
Step 2
the slot, and the ejector button pops out toward you. (See
Flash Disks and Flash Memory Cards in the GRP
36
Installing and Removing Flash Memory Card or Flash Disk
a
The Flash memory card or Flash disk is keyed and cannot be seated the wrong way. The
ejector button will not pop out if the card is not properly inserted.
b
c
Figure 14a.)
Figure 14b.)
78-4339-09