Standard Model - Omron S8VS-24024A -F Series Manual

480-W Models

Standard Model

S8VS-48024
1 2
Models with Indication Monitor
S8VS-48024@
1 2
9
10
16
15
14 13 12 11
Note: The illustration shows the S8VS-48024A model.
* The terminal arrangement is the same for models with screwless
terminal blocks and standard models.
No.
1
2
3
4
5
6
4
5
3
7
6
7
8
8
4
5
9
3
10
11
12
13
14
15,
16
*1. The fuse is located on the (L) side. It is NOT user replaceable.
*2. This is the protective earth terminal specified in the safety standards.
*3. S8VS-48024A/B only.
*4. S8VS-48024A only.
*5. S8VS-48024B only.
Name
AC Input terminals Connect the input lines to these
(L), (N) terminals. *1
Protective Earth Connect the ground line to this
terminal (PE) terminal. *2
DC Output terminals Connect the load lines to these
(−V), (+V) terminals.
Output indicator Lights while a direct current (DC)
(DC ON: Green) output is ON.
Output voltage adjuster
Use to adjust the voltage.
(V.ADJ)
Indicates the measurement or set
Main display (Red) *3
value.
Lights up when the output voltage is
V indicated. Blinks during setup of
undervoltage alarm value.
Lights up during indication of output
A
current.
Lights up during indication of peak
Apk
hold current.
Operation
Lights up during indication of
indicator
maintenance forecast monitor.
(Orange) *3
Yrs Blinks during setup of maintenance
forecast monitor setting. (S8VS-
48024A)
Lights up during indication of total
run time monitor. Blinks during setup
kh
of total run time monitor. (S8VS-
48024B)
Use the Mode Key to change the
Mode Key *3 indicated parameter or reset the
peak hold current value.
Use the Up Key to change to the
Up Key *3 setting mode or to increase the set
value.
Use the Down Key to change to the
Down Key *3 setting mode or to decrease the set
value.
Undervoltage
output terminal
(DC Low)
Output when a drop is detected in
(Emitter side)
the output voltage (voltage drop =
Undervoltage
transistor OFF).
output terminal
(DC Low)
(Collector side)
Maintenance
Forecast Output when the set value for
output terminal maintenance is reached (transistor
(Yrs) *4 OFF).
Alarm
(Emitter side)
outputs
Total run time
*3
output terminal Output when the set value for total
(kh) *5 run time is reached (transistor OFF).
(Emitter side)
Maintenance
Forecast Output when the set value for
output terminal maintenance is reached (transistor
(Yrs) *4 OFF).
(Collector side)
Total run time
output terminal Output when the set value for total
(kh) *5 run time is reached (transistor OFF).
(Collector side)
NC (Not connected)
Always ground this terminal.
S8VS
Function
17