2.5 Remote Control Antenna Angle
(1) Adjust the angle of the remote control antenna and try to face the
flight direction of the aircraft as much as possible.
(2) Long-distance state, the distance between the two antennas is properly
tightened to maintain the antenna directivity.
(3) Closer Sate, the two antennas are properly separated to maintain a
wide receiving range.
(4) Do Not Form an occlusion or cross bettern the antennas.
2.6 Transmitter Calibration
Start Calibration: Push and hold both sticks to the upper left corner as shown
in picture below, and power on the transmitter, the transmitter will enter
calibration state and start Beeping; release the power button and sticks.
Calibrate Sticks: Rotate both sticks in circles to their maximum travel for at
least three times, and release the sticks
Exit and save calibration: long-press any button except the power button
until the remote controller stops beeping and the screen lights on
10