Table of Contents
Advertisement
UNPACKING
Hatco Quick Thaw units are shipped from the factory
partially assembled. (See Figure 3.)
1. Remove HQT-1 unit parts from box.
2. Remove information packet. To prevent delay
in obtaining warranty coverage, fill out and
mail in the warranty card.
3. Remove tape and protective packaging from all
surfaces of unit.
LOCATION
NOTE: A qualified plumber is recommended for
providing hot and cold supply water lines with shut
off valves to the designated HQT-1 location.
Locate the unit to the left side of the incoming water
line and close to a drain in compliance with State
and local plumbing codes.
Left Side Panel
Hinged Door
For safe and proper operation, the unit must
be located at a reasonable working height.
To avoid injury or damage to the unit Hatco
mounting gussets must be used when mounting
unit to the wall. Mounting gussets have a
maximum
(23 kg).
To avoid injury or damage to the unit mount unit
to wall with proper hardware depending on wall
material. (Hardware not supplied.)
To avoid injury or damage to the unit DO NOT
move or relocate the unit while it contains any
food product.
Figure 3. HQT-1 Components
3
INSTALLATION
WARNING
WARNING
weight
capacity
WARNING
CAUTION
Core Panel
Spray Arm
Right Side Panel
Water Manifold
Shelf/Drain Unit
Shelf Gusset
Form No. HQTM-0206
of
50
lbs.
Advertisement
Table of Contents
