Table of Contents
Advertisement
MAINTENANCE
GENERAL
The Hatco Quick Thaw units are designed for
maximum durability and performance, with minimum
maintenance.
CLEANING
WARNING
To assure safe and proper operation additional
cleaning may be required depending upon
products being thawed and local codes applying
to sink thawing techniques.
WARNING
To avoid unsafe conditions do not mix products
that may contaminate each other during thawing
process.
CAUTION
Do not use harsh chemicals such as bleach or
cleaners containing bleach.
CAUTION
Cleaning and sanitizing is recommended at the
end of each days use.
CAUTION
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit
marring
its
appearance
susceptible to soil accumulation.
The cavity housing has been designed to allow for
easy disassembling, cleaning, and sanitizing. It is
recommended to clean and sanitize the HQT-1 at
the end of each days use.
1. Turn off water supply at the hot and cold shut off
valves.
2. Disconnect spray arm from water manifold and
remove from cavity housing for cleaning.
3. Lift the left side of the cavity housing out of
shelf/drain assembly. Move cavity housing to the
left until the water manifold union is cleared.
4. Remove
cavity
assembly and disassemble for cleaning and
sanitizing.
5. Clean and sanitize the drain shelf.
6. Refer to CAVITY ASSEMBLY section, and
Steps 5-7 in the SHELF INSTALLATION section.
Form No. HQTM-0206
and
making
housing
from
shelf/drain
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
This product has no "user" serviceable parts. To
avoid
damage
to personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Replacement Parts
when service is required.
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
it
10
WARNING
WARNING
to
the
unit
or
WARNING
parts
do
not
have
injury
the
Advertisement
Table of Contents
