Table of Contents
Advertisement
TIMER DEVICE (OPTIONAL)
Set Clock
1. Slide switch (located on the back of the unit) to
"CLOCK SET."
2. Press "CLOCK" to select 12 or 24 hour display.
3. Press "H" to set hours. Press "M" to set minutes.
Press "S" to reset seconds to zero.
4. Slide switch back to "CLOCK/TIMER" for timer
operation.
Program Timer #1
1. Press "T1," a "ONE" icon will appear above the
seconds digits.
2. Press "RECALL/CLEAR." The timer digits will
flash.
3. Press "H" to set hours, "M" to set minutes, and
"S" to set seconds. To start over, press
"RECALL/CLEAR."
4. Press "START/STOP" to start timer countdown.
Press again to pause or resume countdown.
5. At "00:00," the alarm will beep. The timer will
begin to count up. Press "START/STOP" to stop
alarm. Press again to pause timer. Press
"RECALL/CLEAR" to recall the last set time.
Press again to reset to zero.
6. Press "CLOCK" to return to clock function. Timer
#'1's digits will stop flashing.
Program Timer #2
1. Press "T2." The clock digits will change to a timer
with a "TWO" icon.
2. Follow timer setting instructions as listed under
Timer #1.
3. To view the clock during Timer #2 countdown,
press "CLOCK." The timer will continue to
operate. Press "T2" again to view Timer #2
countdown.
4. When both timers are in use, press "T1" or "T2"
to toggle between timer operations.
5. Each timer will count up to 23 hours, 59 minutes
and 59 seconds.
CLOCK
RECALL
CLEAR
H
Figure 10. Timer Device
Count Up Feature
1. Both timers will also count up. Press "T1" or "T2"
to select a timer.
2. Press "RECALL/CLEAR" until the display shows
"00:00."
3. Press "START/STOP" and the timer will count
up. Press "START/STOP" again to pause or
resume timing. Press "RECALL/CLEAR" to recall
the last set time. Press again to reset to zero.
NOTE: There is a static cling label over the digital
display and a strip under the battery cover to
prevent battery drain during shipping. Remove both
before use.
9
OPERATION
23:59
59
12:59
59
T1
T2
M
S
Form No. HQTM-0206
Advertisement
Table of Contents
