Summary of Contents for Hatco THERMO-FINISHER TF-1919
Page 1
THERMO-FINISHER TF-1900 & TF-4600 Series Operating Manual This manual contains important information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor.
This manual provides the installation, safety and operating instructions for the Thermo-Finisher Food Finisher. We recommend all installation, operating and safety instructions appearing in this manual be read prior to installation or operation of your Hatco Form No. TF1946M-1004 Programming The Unit...7 General ...7 Programming Controller ...8...
Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to...
A plate rack is included. MODEL TF-1919 The TF-1919 model features one upper element to heat the food product on the plate and one lower element to heat the center of the plate. Loading and unloading of food is done on the control side of the unit.
Model Voltage TF-1919 380 (CE) TF-4619 380 (CE) TF-461R Model Voltage TFW-461R The electrical information in the shaded areas pertains to Export models only. Power cord is attached without a plug. † NOTE: Model TFW-461R must be properly hard wire connected by a qualified electrician.
Do not locate unit under shelving or closer than 12" (305 mm) from the ceiling. WARNING On TF-1919, TF-4619 and TF-461R models allow a minimum of 1" (25 mm) clearance along the sides and back. Allow a clearance of 26"...
INSTALLATION CAUTION Unit is not weatherproof. For safe and proper operation locate the unit indoors where the ambient air temperature is a minimum of 70°F (21°C). ELECTRICAL CONNECTIONS (TFW-461R) WARNING To prevent injury or damage to the unit, TFW-461R model must be installed by a qualified electrician.
GENERAL Thermo-Finisher units have both an upper and ™ lower heating zone. The upper elements heat the product on the plate and the lower elements heat the center of the plate. Five adjustable program button selections allow the operator to fine tune the radiant heat input and heating time for a variety of menu items.
PROGRAMMING CONTROLLER PROGRAMMING A SELECTION The following terms are used when programming the unit: UP = Upper Power Value: Controls the power setting on the upper heating element(s) UT = Upper Time Value: Controls the time setting on the upper heating element(s) LP = Lower Power Value: Controls the power setting on the lower heating element(s) LT = Lower Time Value: Controls the time setting...
Page 11
UPPER HEAT LOWER HEAT Figure 7. Programming a Selection PROGRAMMING CONTROLLER Form No. TF1946M-1004...
PROGRAMMING CONTROLLER IDLE MODE The Thermo-Finisher features an “Idle” mode. ™ Once the unit reaches the heating element(s) automatically go into a programmed idle power setting. (The display will still show during the idle mode). The unit will stay in this mode until one of the five Program buttons is pressed, or the unit goes into auto-shut off.
OPERATION BASIC FOOD FINISHING CAUTION Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury. CAUTION DO NOT use “Pyrex” glass plates or serving pieces in the finisher. “Pyrex” glass may break causing personal injury...
Some aftermarket or generic replacement characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to use Hatco Replacement Parts may subject operators of the equipment to hazardous electrical voltage, resulting in electrical shock or burn.
PAN USED: hardcoated half sheet pan. Chicken Skewers Filleted and marinated. PAN USED: Hatco skewer holder. Chicken Wings Buffalo style, slacked, fully cooked, sauce coated. PAN USED: Half sheet pan. NOTE: All food items listed are utilizing the bottom set of pins for supporting the wire plate rack.
Page 17
Upper Power Value Food Item Egg Rolls Refrigerated, chicken & pork. PAN USED: Half sheet pan. French Fries Frozen, fast-food oven bake style. PAN USED: Half sheet pan. French Onion Soup Soup already hot, for melting cheese. PAN USED: Standard soup crock placed on a half sheet pan.
Page 18
Upper Power Value Upper Time Value Food Item Pork Sausage Links Skinless, raw. PAN USED: Half sheet pan, greased lightly. Potato Skins Frozen, pre-prepared. PAN USED: Hardcoated half sheet pan. Quesadillas 10 " (25 cm) flour tortillas, stuffed with sauteed peppers, onions &...
Hatco reserves the right to accept or reject any such claim in whole or in part. Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer’s sole expense.
Moline 309-797-5323 Service Plus Flanders P.O. Box 340500, Milwaukee, WI 53234-0500 U.S.A. Parts & Service Fax (800) 690-2966 Printed in U.S.A. October 2004 HATCO AUTHORIZED PARTS DISTRIBUTORS NEW YORK Acme American Repairs, Inc. 317-545-9655 Brooklyn Alpro Service Co. Brooklyn 319-323-1823...