Troubleshooting Guide; Troubleshooting - Stihl BGA 45 Instruction Manual

22 Troubleshooting Guide

22 Troubleshooting Guide

22.1 Troubleshooting

Always remove the activation key before carrying out any inspection, cleaning or maintenance.
Condition LEDs on the
blower
3 LEDs flash
red.
Blower does not start
when switched on.
1 LED flashes
green.
3 LEDs glow
red.
Blower cuts out 3 LEDs glow
during operation. red.
Run-time is too short.
Blower is not being 3 LEDs glow
charged. red.
0458-719-8621-A
Cause Remedy
Malfunction in ► Do not attempt to use. The blower has a malfunction and
blower. must be checked by a servicing dealer.
Activation key not ► Remove the activation key, @ 13.2.
fully inserted.
► Visually check the electrical contacts of the activation key.
► Reinsert the activation key, @ 13.1.
Less than 20 % ► Charge the blower, @ 10.
charge remaining.
Integrated battery ► Remove the activation key, @ 13.2.
too hot.
► Allow the blower to cool down gradually at ambient
temperatures of about 50 °F to 68 °F (10 °C to 20 °C).
Moisture in blower. ► Allow the blower to dry.
Integrated battery ► Remove the activation key, @ 13.2.
too hot.
► Allow the blower to cool down gradually at ambient
temperatures of about 50 °F to 68 °F (10 °C to 20 °C).
Electrical ► Switch off the blower. Wait at least 5 seconds and switch it
malfunction. back on, @ 14.
Blower not fully ► Charge the blower, @ 10.
charged.
Useful life of ► Have the blower checked by an authorized STIHL servicing
integrated battery dealer.
has been reached or
exceeded.
Integrated battery ► Allow the blower to warm up or cool down gradually at
too hot / too cold. ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
Integrated battery ► Allow the blower to warm up or cool down gradually at
too hot / too cold. ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
► Operate the charger only in enclosed, dry rooms at ambient
temperatures of 32 °F to 104 °F (0 °C to 40 °C).
English
23