Troubleshooting Guide; Blower - Stihl BGA 300.0 Instruction Manual

English

23 Troubleshooting Guide

23.1 Blower

Always remove the battery before carrying out any inspection, cleaning or maintenance.
Condition LEDs on
Battery
Blower does not start
when switched on.
1 LED flashes
green and six
long beeps are
emitted.
1 LED glows
red.
4 LEDs flash
red and a rapid
succession of
short beeps is
emitted.
3 LEDs glow
red.
3 LEDs flash
red.
26
Cause Remedy
No electrical contact ► Remove the battery, @ 14.2.
between blower and
► Visually check the electrical contacts on the battery-side
battery.
plug and on the battery.
► Reinsert the battery, @ 14.1.
Battery has low ► Charge the battery as described in its instruction manual.
charge.
Battery too hot / too ► Allow the battery to warm up or cool down gradually at
cold. ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
Malfunction in ► Remove and reinsert the battery, @ 14.
battery.
► Switch on the blower, @ 15.1.
► If the LEDs continue to flash, do not attempt to use.
The battery has a malfunction and must be replaced.
The trigger switch is ► Switch on the blower as described in this instruction
already depressed manual, @ 15.1.
before the retaining
latch is pushed
forward.
Blower too hot. ► Allow the blower to cool down.
Malfunction in ► Remove and reinsert the battery, @ 14
blower.
► Switch on the blower, @ 15.1.
► If the LEDs still flash, do not attempt to use.
The blower has a malfunction and must be checked by a
servicing dealer.
23 Troubleshooting Guide
0458-724-8201-A