HP EliteBook 840 G9 Maintenance And Service Manual page 84

Table 5-13 Fingerprint reader description and part number
Description
Fingerprint reader
NOTE: The fingerprint reader spare part kit does not include the fingerprint reader bracket or fingerprint
reader cable. The fingerprint reader bracket is included in the Bracket Kit, spare part number N09030-001. The
fingerprint reader cable is included in the Cable Kit, spare part number N09040-001.
Before removing the fingerprint reader, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the right speaker (see
Remove the fingerprint reader:
1. Remove the Phillips M2.0 × 2.5 broad head screw (1) that secures the fingerprint reader and bracket to the
computer.
2. Remove the fingerprint reader bracket (2).
The fingerprint reader bracket is included in the Bracket Kit, spare part number N09030-001.
3. Release the ZIF connector (3) to which the fingerprint reader cable is connected, and then disconnect the
fingerprint reader cable from the system board.
4. Detach the fingerprint reader cable (4) from the top cover/keyboard. (The fingerprint reader cable is
attached to the top cover/keyboard with double-sided adhesive.)
5. Remove the fingerprint reader (5) and cable.
Reverse this procedure to install the fingerprint reader.
78 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 47).
Speakers on page 51).
45).
Spare part number
N08532-001
45).