Table of Contents
Advertisement
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
If you are replacing a memory module, remove the existing memory module:
1.
Remove the memory module shield.
The memory shield is included in the Bracket Kit, spare part number N09030-001.
2.
Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then remove
the module (2). Use the same procedure to remove all memory modules.
IMPORTANT:
To prevent damage to the memory module, hold the memory module by the edges only. Do
not touch the components on the memory module.
Bottom cover on page
45).
Battery on page
47).
Memory modules
53
Hide quick links:
Advertisement
Table of Contents
