Table of Contents
Advertisement
Available languages
Available languages
Emparejamiento de control remoto
ㆍColoque el control remoto a menos de 10 cm del dispositivo.
ㆍPresione simultáneamente la Tecla de inicio
y la Tecla de menú
hasta que la luz indicadora comience a parpadear y se escuche
un sonido "Di".
ㆍEsto significa que el control remoto ingresa al modo de emparejamiento.
ㆍCuando escuche el sonido "DiDi", la conexión se realiza correctamente.
10 cm
Luz indicadora
Mantenga presionado para emparejar *
* Si el emparejamiento no sea exitoso, repita los pasos anteriores
después de que la luz indicadora deje de parpadear.
24
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Mars Pro and is the answer not in the manual?
Questions and answers
всё работает,а лазер лампа проектора не светится,что делать,какая причина..
If the laser lamp of the Dangbei Mars Pro projector is not lighting up, follow these steps:
1. Check Power Connection – Ensure the projector is properly plugged in and receiving power.
2. Observe LED Indicator – When pressing the power button, if the LED flashes and the fan turns on but no image appears, this indicates a potential issue.
3. Restart the Projector – Unplug the projector, wait a few moments, then plug it back in and try turning it on again.
4. Inspect Ventilation – Ensure that the air intake and exhaust vents are not blocked, as overheating could prevent the laser from activating.
5. Factory Reset – If possible, reset the projector to its default settings.
6. Contact Support – If the issue persists, the laser module may have failed, requiring professional repair or replacement.
If the projector repeatedly powers off after attempting to start, it may indicate hardware failure. Contact Dangbei customer support for further assistance.
This answer is automatically generated