Dangbei Mars Pro User Manual page 15

Hide thumbs Also See for Mars Pro:
Table of Contents

Advertisement

Available languages

Available languages

IC STATEMENT
CAN ICES-3 (B)/NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme canadienne ICES-003.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's
licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
1.L'appareil ne doit pas produire de brouillage;
2.L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
For projectors only
The distance between user and products should be no less than 20cm.
La distance entre l'utilisateur et le produit ne doit pas être inférieure à 20 cm.
5.2 GHz band is restricted to indoor use only.
La bande de 5.2 GHz est réservée à l'usage intérieur.
14

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Mars Pro and is the answer not in the manual?

Questions and answers

Валера
March 16, 2025

всё работает,а лазер лампа проектора не светится,что делать,какая причина..

1 comments:
Mr. Anderson
March 16, 2025

If the laser lamp of the Dangbei Mars Pro projector is not lighting up, follow these steps:

1. Check Power Connection – Ensure the projector is properly plugged in and receiving power.
2. Observe LED Indicator – When pressing the power button, if the LED flashes and the fan turns on but no image appears, this indicates a potential issue.
3. Restart the Projector – Unplug the projector, wait a few moments, then plug it back in and try turning it on again.
4. Inspect Ventilation – Ensure that the air intake and exhaust vents are not blocked, as overheating could prevent the laser from activating.
5. Factory Reset – If possible, reset the projector to its default settings.
6. Contact Support – If the issue persists, the laser module may have failed, requiring professional repair or replacement.

If the projector repeatedly powers off after attempting to start, it may indicate hardware failure. Contact Dangbei customer support for further assistance.

This answer is automatically generated

Subscribe to Our Youtube Channel

Table of Contents

Save PDF