Table of Contents
Advertisement
Available languages
Available languages
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
13
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Mars Pro and is the answer not in the manual?
Questions and answers
всё работает,а лазер лампа проектора не светится,что делать,какая причина..
If the laser lamp of the Dangbei Mars Pro projector is not lighting up, follow these steps:
1. Check Power Connection – Ensure the projector is properly plugged in and receiving power.
2. Observe LED Indicator – When pressing the power button, if the LED flashes and the fan turns on but no image appears, this indicates a potential issue.
3. Restart the Projector – Unplug the projector, wait a few moments, then plug it back in and try turning it on again.
4. Inspect Ventilation – Ensure that the air intake and exhaust vents are not blocked, as overheating could prevent the laser from activating.
5. Factory Reset – If possible, reset the projector to its default settings.
6. Contact Support – If the issue persists, the laser module may have failed, requiring professional repair or replacement.
If the projector repeatedly powers off after attempting to start, it may indicate hardware failure. Contact Dangbei customer support for further assistance.
This answer is automatically generated