Nilfisk-Advance OZ 1 Information & Operating Instructions page 6

For Automobiles:
WARNING!
Important!: Only use Nilfisk original accessory, car kit part number 600400100, for treatment in
automobiles.
Refer to Figure 1 and Figure 2 below.
1. Install the hose over the electrode chamber. Secure the hose with the hose clamp.
2. Set the Nilfisk OZ 1 on top of the car, or on a table or cart next to the car.
3. Install the foam block into a partially open window, and place the open end of the hose
through the hole in the foam.
4. Set the timer and the output level.
5. Turn ON the machine.
6. When treatment is complete, ventilate the car completely. Repeat treatment if necessary.
Figure 1:
HOSE
CLAMP
CAUTION: BE SURE TO KEEP THE AIR INTAKE FILTER CLEAN
DO NOT INHALE FUMES
Figure 2:
FOAM
6