Table of Contents
Advertisement
Operating instructions
LIFTING INSTRUCTIONS
When lifting the compressor, the hoist has to be placed in
such a way that the compressor, which must be placed
level, will be lifted vertically. Use the lifting bale provided
to lift the unit
Lifting acceleration and retardation must
be kept within safe limits (maximum 2g).
Helicopter lifting is not allowed.
BEFORE STARTING
If the compressor is to be connected to a
common compressed air system, fit an
appropriate check valve between
compressor outlet and air system. Observe
the right mounting position/direction!
- 22 -
1. Before initial start-up, prepare battery for operation if
not already done.
2. With the compressor standing level, check the level of
the engine oil. Add oil, if necessary, to the upper mark
on dipstick. Consult the Engine Operation Manual for
the type and viscosity grade of the engine oil.
3. Check the level of the compressor oil. The pointer of oil
level gauge (OLG) should register in the green range.
Add oil if necessary.
4. Check that the fuel tank contains sufficient fuel. Top up,
if necessary. Consult the Engine Operation Manual for
the type of fuel.
5. Check coolant level in overflow bottle. Top up coolant
if necessary. Consult engine's operation manual for
water/coolant specifications.
6. Drain any water and sediment from the fuel filter until
clean fuel flows from the drain cock.
7. Press vacuator valve (VV) of the air filter to remove
dust.
8. Check the air filter service indicator (VI). If the red part
shows completely, service or replace the filter element.
Reset the indicator.
9. Open an air outlet valve (AOV) (1) to allow air flow to
the atmosphere.
Advertisement
Table of Contents
