Verifying The Connection - Keysight Technologies E2655C User Manual

Verifying the Connection

1
2
3
4
Figure 3
If you see a waveform similar to that of
and should check all of your probe connections.
E2655C Probe Deskew and Performance Verification Kit User's Guide
On the Infiniium oscilloscope, press the [Auto Scale] key on the front panel.
Set the volts per division to 100 mV/div.
Set the horizontal scale to 1.00 ns/div.
Set the horizontal position to approximately 3 ns. You should see a waveform
similar to that in Figure
Good Connection
3.
Figure 4 then you have a bad connection
9