idp SMART Series User Manual page 70

14 Init Error
15 DeviceCon Error
16 Lami Error
17 Flipper Error
18 Ribbon Zero
19 RibbonNotFound
20 TPH Not Found
21 TPH Over Heat
22 Invalid Data
-. Check the rollers, encoders and cards, and clean them if they are polluted
Error occurs while initializing
-. Check the status of installation of ribbon and laminating film
-. Check the laminator turning on if the laminator is installed
Fail to communicate between a printer and a flipper/laminator
-. Check the laminator turning on if the laminator is installed
-. Check a cable between a printer and a flipper/laminator
Error occurs while laminating
-. Remove a card after opening a laminator top cover
-. Check usage of a genuine laminating film and cards
Error occurs while operating a flipper
-. Remove a card after opening a flipper cover
-. Check the card size
All ribbons are used
-. Install the new ribbon after purchasing it in the place of purchase
Ribbon is not installed or not searched
-. Install a ribbon if not
-. Check usage of a genuine ribbon
Thermal Print Head is not installed or not recognized
-. Check the print head installation
-. Contact the place of purchase
Thermal Print Head is overheated
-. Lower the temperature when the temperature of circumstance is too high
-. Take a stop for 10 minutes and print again.
-. Contact the place of purchase if this message is shown regularly
Error occurs when the abnormal printing data is transmitted.
-. Replace the USB cable USB
-. Change the USB port in the PC
-. Reinstall the printer driver
70